How to reset a range rover computer?

1. To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
2. The device will power down and then automatically reboot.
3. Device will now power on, perform and charge as expected.

Also know, how do you reset a Range Rover 2018?

Likewise, how do you reset the 2016 Range Rover? Turn the ignition to “on” without igniting your engine (if you have push-button start, press your button once without touching the brake pedal. Open the driver’s door. Depress and hold the gas and brake pedals for 60 seconds. Then turn the ignition to “off” and verify that the light has been reset.

People ask also, how do I reset my Range Rover transmission?

1. Press Start button but don’t turn on the engine.
2. Press the Accelerator down to the floor for about 15 seconds.
3. Hit the start button again to turn off the power.
4. Remove foot from Accelerator.
5. Waity for 2 Mins.
6. Start the engine and Drive.

Also, how do you reset a Range Rover Evoque?

1. Go to Settings menu.
2. Select “Backup & Reset”, select “Factory data reset”
3. Select “Reset phone” and “Erase everything”
4. The device will then reboot.

How do you reset the service light on a 2015 Range Rover?

1. Key on, engine OFF.
2. Open door.
3. Open bonnet (hood)
4. Depress the accelerator pedal simultaneously for ten seconds, release.
5. service interval is now reset.

How do you put a Range Rover in service mode?

How do you reset the service light on a 2015 Range Rover Sport?

How do you clear the code on a Range Rover?

1. use a code reader.
2. disconnect the battery leads for a couple minutes.
3. cycle the key on and off more than 40 times. Note, this one requires the problems to be fixed before it worksthe other 2 ways do not, although the codes will return in 2 trips, otherwise.

What does gearbox fault mean on a Range Rover?

The gearbox fault message is often triggered by insufficient battery voltage. It’s a strange sort of Land Rover code – you know, gearbox fault REALLY means battery bad.

How do I reset my Range Rover Smart Key?

Position the Smart key flat against the side of the steering column. There are markings on the steering column to help locate the correct position. While holding the Smart key in position, firmly press and hold the brake pedal. Press and release the engine START/STOP button.

How do you reset the maintenance light on a 2016 Range Rover Evoque?

How do I get my Range Rover out of valet mode?

1. From the Home menu screen, select Valet.
2. Enter a memorable 4 digit PIN. You will be prompted to confirm the PIN. If you wish to cancel the PIN, select Delete.
3. Valet mode activated is displayed to indicate that a PIN has been accepted.

How do I reset my PIVI pro?

To reboot Pivi, simply hold the power/volume button for as long as needed (30”).

How do I know if my Range Rover has InControl?

How do I know if I have InControl on my used vehicle? The overhead console will have two flaps which can be pressed open to reveal the emergency call button (SOS icon) and the Optimized Land Rover Assistance button (spanner icon). If you are in any doubt, please contact your Retailer.