Turn the ignition to the ON position. Do not start the engine. Press and release the “Select/Reset” stem button on the instrument panel to toggle the options until the “Hold Reset For Setup Menu” option appears. Press “Select/Reset” to toggle the options until the “Hold Reset if New Oil” option appears.
Also, how do you reset the oil light on a 2015 Ford Explorer?
Likewise, how do you reset the oil light on a 2017 Ford Explorer?
Also know, how do you reset the oil life on a 2013 Ford Explorer?
People ask also, how do you reset the oil change light on a Ford? Press and hold the trip/reset button until the display reads “OIL LIFE SET TO 100%.” Turn the ignition to the “OFF” position. Start the engine and verify that the oil change required message is no longer displayed.
- Switch the ignition over to the on position.
- Go to the SETTINGS menu.
- Scroll and select VEHICLE.
- Scroll down to OIL LIFE RESET.
- Press and hold the OK button.
- Shut the vehicle off and then start it back up and check the oil change light should be gone.
Contents
What does it mean to change engine oil?
An Oil Change is the act of removing the used oil in your engine and replacing it with new, clean oil. … These factors make oil much less slippery and less effective at their job of lubricating engine parts. That’s why it’s important to change your oil according your car’s specifications.
How do you reset the oil light on a 2012 Ford Explorer?
To reset the oil level warning or maintenance light in your 2012 ford explorer vehicle, turn the ignition key to the “on” position and depress the gas pedal slowly three times. Release and start your vehicle and oil light should indicate a reset.
How do you reset the oil light on a 2011 Ford Explorer Limited?
To reset the ford explorer oil life light, put the ignition into on without starting engine. Use the pad on the steering wheel to scroll through the settings. Go to settings, vehicle, oil life reset. Push and hold ok.
How do I reset my oil change?
How do I reset my oil light?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
How do I reset my Ford Escape after oil change?
Using the information display controls on the steering wheel, scroll to ‘Settings’ and press the right arrow button. Scroll to ‘Vehicle’ and press the right arrow button. Scroll to ‘Oil Life’ and press the right arrow button. Press and hold the OK button until a ‘Reset Successful’ message appears.
Can you just add oil instead of changing?
Dark colored, cloudy or gritty textured oil is a sign the lubricating components of the oil have been exposed to heat for too long and needs to be changed. Adding oil instead of an oil change at this point could cause engine issues. This used oil needs to be removed to allow new oil to lubricate your engine’s parts.
Why does my oil light keep going on and off?
If the oil light flickers on and off while the vehicle is stopped or at an idle, there may be a problem with the oil sensor or the pressure is too low. … Check the oil level and add motor oil to the vehicle, if needed, and continue to monitor the light. If the oil was indeed low, the light should turn off.
Does a car run better after an oil change?
Smooth Ride. If you haven’t had regular oil changes in the past, you probably notice a significant difference in how the car performs before and after the oil change. Once the oil change is complete, your vehicle runs smoothly and with more power.
How do you reset the oil light on a Ford Ecosport?
Turn the ignition on without turning on the engine. Press both the break and gas pedals at the same time. After a few seconds the screen should say “service: oil reset in prog.” Keep pressing down on the break and gas for about 25 seconds until the screen says “service: oil reset complete”.