Place Your physical key into the ignition key hole, and turn it to the on position three times in a 10 second period. Now, start the engine, and the anti-theft system should be reset.
Also know, where is the reset button on a 2001 Ford Explorer?
Also, how do you bypass anti-theft system on a 2001 Ford Explorer? First, go to the driver’s side of Your vehicle, and insert the key into the lock. Turn the lock to the right, or to the unlock position. Hold this position and count for 25 to 40 seconds. Doing this will bypass the anti-theft system.
Likewise, where is the reset button on a Ford Explorer? To reset the fuel light on a ford explorer you will need to access the fuel reset switch which is located in the glove box or in the foot well of the passenger seat area, press that switch and the fuel system will be reset.
People ask also, how do you reset a PCM Ford Explorer?
- Open the hood of the Ford. Loosen the lock nut located on the negative battery cable connector with a socket and ratchet.
- Wait for 20 minutes while the PCM bleeds off the electricity it stores for backup power. Once the power drains from the PCM, it resets.
To reset the anti-theft system on a 2000 ford explorer you need to roll down a window and lock all doors from the inside except the drivers, then use the key to lock the drivers door.
Contents
How do you reset the fuel pump on a 2000 Ford Explorer?
It’s in the passenger side footwell, up about 8″ from the floor. The button should be just above the top of the plastic kick panel.
How do I get my car out of anti theft mode?
Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.
How do I get my 2002 Ford Explorer out of theft mode?
To begin, turn the key in the ignition as if You were trying to start the engine. The engine won’t start since the anti-theft system has been activated. Allow the key to fall back into the ON position so the dashboard lights and radio still work. Leave the key like this for at least 10 minutes.
How do I reset my Ford anti-theft system?
Turn the ignition to the off position and remove the second coded key from the ignition. After three seconds and before 20 seconds, insert the new uncoded key into the ignition. Turn the ignition to the on position and keep it on for at least 6 seconds. Remove the newly coded key from the ignition.
How do you clear the code on a Ford Explorer?
The first way is to connect an OBD-II scan tool and clear the trouble codes, so long as they are not permanent codes. Another is to disconnect the battery for at least 10 to 15 minutes. Once the power is reconnected, the light should have reset.
How do I reset my Ford Explorer screen?
How do you reset an engine control module?
How do you diagnose a bad PCM?
- Your “check engine” light is on.
- Other warning lights may be on, including traction control and ABS.
- You lose fuel economy for no apparent reason.
- Your car stutters when starting, requires multiple attempts, or won’t start at all.
- Stuttering or stalling during idling.
How do you reprogRam a PCM?
To reprogram a PCM or other vehicle module, you need a factory scan tool, or an aftermarket scan tool with reprogramming capabilities, or a J-2534 compliant “PassThru” interface tool (or J-2534-1 for 2004 & newer vehicles) that can connect a PC or scan tool to the vehicle’s diagnostic connector or module.
How do you reset the battery on a Ford Explorer?
1) Ignition on (engine off), headlight flashers 5 times, then brake pedal 3 times. Battery indicator lamp will flash meaning success. 3) Ignition on (engine off), lights on, fog light button 5 times, then hazard 3 times. Battery indicator lamp will flash meaning success.