Put your key in the ignition and turn it to position one, which is the position right before starting the car. Push and hold the trip meter reset button on the dashboard, then turn the key to position two. Keep holding the odometer button for 10 seconds. The light should then flash, beep, and then go out.
You asked, how do you reset the maintenance light on a 2016 Toyota Rav4?
Beside above, how do you reset the maintenance required light on a 2012 Toyota Rav4?
- Turn on your car without starting.
- Make sure you are on TRIP A screen.
- Switch off the ignition.
- Hold down the ODO/TRIP button while turning the car back on.
- Keep holding it until you see zero and you’re done.
Also, how do you reset the maintenance light in a 2015 Toyota Rav4? To reset the maintenance light on a 2015 toyota Rav4, first turn the ignition to on, then set the odometer to read “odo”. Turn ignition to off. Push and hold the trip reset button at the same time turning the ignition back to on.
Considering this, how do you reset the maintenance required light on a Toyota Rav4 2017?
Contents
How do you reset the maintenance required light on a 2010 Toyota Rav4?
How do you reset the maintenance required light on a 2019 RAV4?
How do you reset the maintenance light on a Toyota RAV4 2019?
How do you reset the maintenance required light on a 2008 Toyota RAV4?
How do you reset the maintenance required light on a 2011 Toyota Rav4?
How do you reset the maintenance required light on a 2005 Toyota Rav4?
How do you reset the maintenance required light on a Toyota Rav4 2020?
How do you reset the maintenance required light on a Toyota?
Push and hold the trip meter reset button on the dashboard, then turn your key to the second position. Continue to hold the odometer button for 10 seconds total. This should cause the light to flash, possibly beep, then turn off. After it’s off, release the odometer button then start the car.
How do you reset the maintenance required light on a Toyota Rav4 2018?
To reset the maintenance light on a 2018 toyota rav 4: insert the key into the ignition. Press and hold the trip meter reset button. Turn the engine switch to the “on” position. Hold the trip meter reset button until the trip meter displays “000000.” The maintenance light is reset.