If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete. Down button: Press and release to lower the suspension height. If a door is open, press and hold to lower the suspension height.
In this regard, how do you lock the suspension on a 2006 Range Rover? Make sure that the suspension height is set at the access height setting or the normal height setting. Make sure that the vehicle is travelling at a speed of less than 35 km/h (22 mph). Press the down button (2) for longer than 1 second, to lock the vehicle at access height. See ELECTRONIC AIR SUSPENSION CONTROLS.
Similarly, how do you reset the air suspension on a 2006 Range Rover Sport?
Also the question Is, how do you jack up a Range Rover with air suspension? Turn the jack lever (2) clockwise to raise the jack, until it locates into the jacking point. Make sure that the base of the jack is in full contact with the road surface. Raise the vehicle with the jack, until the tyre being lifted just clears the ground. Operate the jack with a slow and steady motion.
Correspondingly, how do you fix a suspension on a Range Rover?
Contents
Where do you jack up a Range Rover Sport?
To raise the vehicle, use the jacking points located on the front and rear of the side tubes, fixed side steps, or deployable side steps.
How does air suspension work on Range Rover?
The design of the air suspension in the Land Rover is impressive. The suspension is controlled electronically and allows the driver to make adjustments. The way the suspension is able to adjust is by a compressor connected to each individual air strut. The air suspension really does make for a smoother and better ride.
How do I keep my Range Rover lowered?
- Press and hold to raise the rear suspension.
- Press and hold to lower the rear suspension.
- Simultaneously press and hold both buttons to set the rear suspension to the normal height setting. A time delay may be evident before the vehicle reacts to a suspension height request via the buttons.
How do I put my Range Rover Sport into access mode?
How do you reset suspension height on a Range Rover?
Selecting a new height using the raise/lower switch 1, or driving off will reset the system. If the vehicle is grounded and traction control is activated, Extended mode is activated automatically to raise the vehicle clear.
What does air suspension inactive mean on a Range Rover?
The reason it went up when they cleared the code is because they reactivated the system and the compressor filled the system… For it to just sink and throw the inactive message up minutes after the codes were cleared means there is something physically wrong, the system is losing air.
How much does it cost to fix a Range Rover air suspension?
Land Rover Range Rover Sport Active Suspension Air Spring Replacement Cost Estimate. Labor costs are estimated between $226 and $286 while parts are priced at $1,544.
Where is the jack in a Range Rover?
If side steps or tubes are fitted, the jacking points are located on the underside of the side step or tube brackets. Before raising the vehicle, correctly position the wheel chocks. See USING WHEEL CHOCKS. Before raising the vehicle or changing a wheel, make sure to read and comply with the following warnings.
Can I drive my Range Rover Sport in access height?
The full access height setting is 2 in (50 mm) below the normal height setting. Auto access height can be activated until 90 seconds after the vehicle becomes stationary. … Alternatively drive the vehicle at a speed above 4.4 mph (7 km/h) for 3 seconds, or at a speed in excess of 9.3 mph (15 km/h).