1. Press MENU.
2. Select Customize Settings.
3. Select TPMS Calibration.
4. Select Initialize.
5. Select Yes.
6. Press MENU to exit.
Contents
How do you reset the tire pressure light on a 2016 Honda Civic?
How do you reset the TYRE pressure on a 2015 Honda Civic?
How do you reset the tire pressure light on a 2010 Honda Civic?
steering wheel
How do you reset the TYRE pressure light on a 2009 Honda Civic?
Why TPMS light on but tires are fine?
TPMS Light stays on all the time This could either mean air pressure in one or more of your tires is low. If you have already checked and know that this isn’t the case, then it could indicate that the TPMS sensor is not reading correctly.10 mar. 2021
Why is my tire pressure light still on after filling tires?
Quick Tip: If the TPMS warning light comes back on after you’ve filled the tire with air, recheck the tire to make sure it is inflated to the proper air pressure. If the tire air pressure is low, you have an air leak and should have the tire fixed or replaced.30 déc. 2015
What is the correct tire pressure for a Honda Civic?
Recommended tire pressure for 2019 Honda Civic is 32 psi to 35 psi for front tires and 32 psi to 33 psi for rear tires.
If your Honda is equipped with a TPMS button, you’ll find it to the left of the steering wheel. Press and hold the button until the warning light blinks twice.19 fév. 2019
How do I reset my TPMS light?
Turn the car key to “on” but don’t start the vehicle. Press and hold the TPMS reset button until the tire pressure light blinks three times. Release the button and start the car. The light should go off within 20 minutes.
How do you reset the TPMS light on a 2011 Honda Civic?
To reset the tpms on the 2011 honda civic make sure the tire pressure is correct, then turn on the vehicle. Now hit the reset button that is to the right of the steering wheel and wait ten minutes. In some cases you may need to hold the button down till the light flashes.
How do you turn off the TPMS light on a 2008 Honda Civic?
Another way to do it is to turn the ignition to on. Press and hold the TPMS button which is located near the lower left knee bolster until the TPMS light blinks twice. Turn the engine off and then start it and it will be reset.
Why is my TPMS not working?
TPMS problems can include any of the following: … The TPMS module itself is not functioning properly or has failed because of a voltage supply, wiring or internal electronics fault. • The tires were serviced or rotated recently and the relearn procedure was not done correctly.