1. Turn the ignition key to the “ON” position without starting the engine.
2. Press the MENU button repeatedly until you see OIL LIFE menu on the display.
3. Scroll down to the “TIRE PRESSURE” menu.
4. Press and hold the SET/CLR button to enter the relearn mode.
Contents
Can I reset my tire pressure monitor?
Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes to reset the sensor. You’ll usually find the tire pressure monitor reset button beneath the steering wheel.
How do you calibrate a Chevy tire pressure sensor?
1. Confirm TPMS sensors are properly installed.
2. Adjust tire pressures to placard value.
3. Apply parking brake.
4. Turn vehicle to ON/RUN.
5. Push the trip odometer reset stem until Tire Pressure is displayed.
6. Push and hold trip reset stem to begin the sensor matching process.
Why wont my tire pressure light go off?
If you’ve inflated your tires to the proper air pressure, but the warning light stays on, you may have a leak or there’s a problem with the TPMS in one or more of your tires. It’s simple enough to check if there’s a leak in a tire. Just use your tire gauge to recheck the air pressure in all your tires.4 jan. 2016
What is the best TPMS relearn tool?
1. VXDAS EL-50448 TPMS Tool for GM – Editor’s Pick.
2. JDIAG 2IN1 EL50448 TPMS Relearn Tool for GM and Ford.
3. Autel MaxiTPMS TS501 TPMS Programming Tool.
4. VXSCAN El-50448 Auto TPMS Reset Tool.
5. ATEQ VT31 TPMS Reset Activation Programmer Tool.
6. Autel TS408 Handheld TPMS Service Tool.
7. Autel TS401 TPMS Programming Tool.
What is a TPMS relearn tool?
VXDAS TPMS Relearn Reset Activation Tool for GM series Vehicles (Chevy / Buick / GMC / Opel / Cadillac etc, from 2006-2021, Cars, SUV, Pickup), equipped with Tire Pressure Monitor system (TPMS) sensor.It can quickly reset tire sensors after you do tire rotation or change a new tire.
steering wheel
Why TPMS light on but tires are fine?
TPMS Light stays on all the time This could either mean air pressure in one or more of your tires is low. If you have already checked and know that this isn’t the case, then it could indicate that the TPMS sensor is not reading correctly.10 mar. 2021
Why is my tire pressure light still on after filling tires?
Quick Tip: If the TPMS warning light comes back on after you’ve filled the tire with air, recheck the tire to make sure it is inflated to the proper air pressure. If the tire air pressure is low, you have an air leak and should have the tire fixed or replaced.30 déc. 2015
How do you reset tire sensors after rotation?
Train the system sensors in the tires using the following reset sequence starting with the left front tire and following a clockwise order: Left front, right front, right rear, left rear. 6. Remove the valve cap from the valve stem on the left front tire. Decrease the air pressure until the horn chirps.19 déc. 2019
How do you reprogram a tire sensor?
Can I reset the TPMS by disconnecting the battery?
Disconnect and Reconnect the Car’s Battery Your car has an onboard computer that checks all the sensors in the vehicle (including the tire pressure sensors) and decides what to do with that information. … A quick and easy way to reset your computer is to disconnect and reconnect your car’s battery.9 avr. 2020
How long does it take for TPMS to reset?
The TPMS reset button should be held until the light blinks three times. If you want to reset the sensor, start the car and let it run for 20 minutes. The tire pressure monitor reset button can be found under the steering wheel.
Is it safe to drive with tire pressure sensor fault?
No, driving with the TPMS Light on is not safe. It means one of your tires is underinflated or overinflated. … This can cause undue wear on the tire, potentially lead to a tire failure, and cause a blowout dangerous to you and other drivers on the road.29 déc. 2015