They are located under the engine cover on top of the camshaft cover on the left side of the engine.22 juil. 2012
Contents
Where is the camshaft position sensor located?
The camshaft position sensor is always located near the camshaft, often at the top of the valve cover, but it can also be installed from the side of the cylinder head. Check around the head or valve cover and follow any electrical wires and you will for sure find the camshaft position sensor.
How many camshaft sensors does a Chevy Malibu have?
There are two camshaft position sensors on the top of the Ecotec LFV 1.5L turbocharged I4 engine. One sensor is located on the front right (driver side) corner of the valve cover. The other sensor is located on the rear right (driver side) of the valve cover below the black plastic pipe connected to the turbocharger.
Where is the crankshaft position sensor on a 2012 Chevy Malibu?
The 2012 Chevy Malibu 2 4Crankshaft position sensor location is different on different makes and models, however, it will always be near the crankshaft itself. If You need to replace the sensor then it will cost You between 190 and 300 dollars, plus another 200 for the labor of having it installed.
How do you change a camshaft sensor on a 2012 Chevy Malibu?
How much is a camshaft sensor for a 2012 Malibu?
We currently carry 8 Camshaft Position Sensor products to choose from for your 2012 Chevrolet Malibu, and our inventory prices range from as little as $22.99 up to $57.99.
Can I drive with a bad camshaft position sensor?
What causes the camshaft sensor to go bad?
Different things can cause the camshaft position sensor to malfunction. It can fail due to use over a long time, moisture, water damage, and oil build up on the engine. This sensor continuously operates when the engine is on. Whether driving or not, if the engine is on, the CMP is working and can get sworn down.
What does a bad camshaft sound like?
The symptoms of a bad camshaft include frequent backfiring and popping. You may also experience cylinder misfires at low and high speeds. Additionally, if your camshaft lobes are worn, you may hear tapping and ticking noises from the upper engine.
What happens if your crankshaft position sensor goes bad?
Vehicle is Stalling and/or Backfiring Along the same lines as the symptom above, a problem with your crankshaft position sensor could cause your vehicle to stall and/or backfire. Stalling is more common than backfiring as the interruption of the crankshaft signal can cause the engine to be cut off.
How much is a camshaft sensor for a 2010 Malibu?
We currently carry 1 Camshaft Position Sensor products to choose from for your 2010 Chevrolet Malibu, and our inventory prices range from as little as $39.71 up to $39.71.
What is the code P0014 for a Chevy Malibu?
A P0014 code refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car’s PCM (powertrain control module) or ECM (engine control module). … In this case, if the cam timing is above a set limit (over-advanced), the engine light will be illluminated and the code will be set.
How do I fix the code P0017?
1. Resetting the engine fault codes and verifying that the problem is still occurring.
2. Replacing the camshaft position sensor on a failed camshaft bank.
3. Repairing or replacing the wiring connection to the camshaft sensor or the OCV.
4. Replacing the Engine Control Module.