The remote positive (+) terminal (1) is located on the underhood fuse block, on the driver side. Lift the red cap to uncover the terminal. The remote negative (−) terminal (2) is a stud behind the metal tab stamped with GND (−) near the driver side strut tower.
Contents
How do you jumpstart a 2014 Chevy Equinox?
Where is the battery located on a 2014 Chevy Equinox?
Where do you connect the negative jumper cables?
The positive (red) cable should be attached to the positive terminals on each battery. The negative (black) cable should have one end attached to the negative terminal of the dead battery, and one end grounded.14 déc. 2016
How long does a Chevy Equinox battery last?
between 3 to 5 years
How do I change the battery in my Chevy Equinox?
Is red positive or negative?
One is marked positive (+), the other negative (-). There are also positive and negative cables in the jumper cable set. The red one is positive (+), the black one is negative (-). Never connect the red cable to the negative battery terminal or a vehicle with a dead battery.
How long should Jumping a car take?
Allow it to run for 1-2 minutes. Rev the engine slightly by pressing on the gas pedal lightly. Start the engine of the dead car. It may take more than one try, but do not try to restart it more than three or four times.
Why is my Chevy Equinox not starting?
While there are a variety of reasons your Chevrolet Equinox won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
How do you change the battery in a 2014 Chevy Equinox key fob?
Where is the battery on a Chevy Equinox 2015?
How do you change the battery in a 2007 Chevy Equinox?
What happens if you connect the negative terminal first?
If you connect the negative terminal first, the car’s entire frame becomes grounded together with the nuts and bolts of the frame. Once you connect the positive terminal and the spanner touches the frame or any grounded part of it, a short circuit may occur that could cause the battery to explode.
What is the correct order to attach jumper cables?
Attach the red jumper cables first. Start by clamping one red cable to the positive side of the battery that won’t start. Then attach the other red clamp to the positive side of the working battery. Next, clamp one black cable to the negative side of the working battery.
Do I connect positive or negative first?
“Positive first, then negative. When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.”