Beside above, how do I put my 2014 Prius into maintenance mode?
Quick Answer, how do you reset the maintenance required light on a Toyota Prius? Keep holding the Prius trip reset button and turn your key back towards the “Off” position. Turn your Prius key to the “On” position. Continue holding your Prius reset button until you see the number near the odometer reach 0. You’ve succeeded in resetting your Toyota maintenance light!
Correspondingly, how do you reset the maintenance light on a 2015 Prius V?
As many you asked, how do you reset the maintenance light on a 2014 Toyota?
Contents
What does Prius maintenance mode do?
Putting your Toyota Prius into maintenance mode – getting the engine to stay running. … Normally the engine only runs to either warm itself up or if the driver is requesting more power, but if you want the engine to idle you’re stuck.
How do you reset the maintenance light on a 2013 Prius?
How do I turn off the maintenance required light?
How do you turn off the maintenance required light on a 2008 Toyota Prius?
How do you reset the oil maintenance light on a 2010 Prius?
How do you reset the maintenance light on a 2010 Toyota Prius?
Turn the ignition “off” to reset the oil light by pressing the start button without touching the brake and holding the mph km / h button. Keep holding the mph km / h button while the reset is going on and until the reset is complete.
How do you reset the maintenance light on a 2014 Prius C?
How do you reset the maintenance required light on a 2014 Toyota Corolla?
- Get in the car and turn it on.
- Press the ODO/ TRIP button repeatedly until you see “TRIP A”
- Shut the ignition off completely.
- Hold down the ODO/ TRIP button while turn on the ignition again.
- Keep holding it until it goes all zero and you’re done.
How do you reset the TPMS on a 2014 Toyota Corolla?
Switch the ignition to “ON“. Locate the tire pressure reset button located on instrument panel, knee bolster or inside glove box. Press and hold the button until the tire pressure light flashes 3 times. Wait for about 3 minutes, then turn the ignition to “LOCK” or “OFF“, and you’re done.