Hold down your car brake and press the power button to turn the car on. Continue holding down the brake, as you press the odometer trip button. Turn the car off while holding the ODO button and brake. After doing so, turn the car back on one more time while still on brake and ODO.
Also, how do you reset the check engine light on a 2011 Toyota Prius? To do this, insert your key into the ignition, turn the vehicle on for about a second, and then off for about a second. Repeat this two more times then drive the car as normal. Check to see if the check engine light reset.
You asked, how do you reset the check engine light on a 2011?
- Turn off the ignition and put on safety glasses and gloves.
- Locate the negative terminal on your car battery.
- Loosen the nut on the negative terminal with a wrench and pull the negative connector from the battery.
- Reconnect the negative cable and tighten it with your wrench.
Best answer for this question, how do you reset the check engine light on a 2012 Toyota Prius?
- Let it go off by itself.
- Turn your ignition on and off several times in a row.
- Disconnect your battery and reconnect it.
- Buy an OBD II scanner (they’re relatively inexpensive) and follow the instructions (it’s pretty easy)
You asked, why is the check engine light on in my Prius? It could be a misfiring engine, a broken oxygen sensor or simply a loose gas cap. When you see the check engine light it doesn’t necessarily mean you need to pull the car over to the side of the road and call a tow truck. It does mean you should get the car checked out as soon as possible.
How do I clear my check engine light without a scanner?
How do you reset the check engine light on a 2010 Toyota Prius?
There is no way to reset the check engine light on the 2010 prius. It comes on when there is something wrong with the car, but it can be caused by just about anything. Due to this, it is not worth Your time hunting down a random issue unless it is something very obvious that has gone wrong.
How do I turn my check engine light off?
How do you clear the code on a Prius?
- Connect the scan tool to the onboard diagnostic connector. This is found under the steering column.
- Press the READ button on the scan tool, and look for any error codes.
- Press the ERASE button on the tool to remove the error code. The check engine light will then turn off.
Will Autozone reset check engine light?
Yes, we can help you clear your code; it’s called telling you how to fix your damn car. Like others have said, even after clearing it, the light will come back on within 30-50 miles of driving.
Will check engine light reset itself?
Your vehicle’s check engine light will will reset by itself once the issue or problem has been repaired; this is true for most models. … If you are certain that you have resolved the issue that caused your check engine light to come on in the first place, then the light should reset itself after at least 20 cycles.
How do you reset the check engine light on a code reader?
Press the “erase/clear” button on your scanner, then turn off the key and disconnect it. Clearing any codes present will turn off your check engine light temporarily. After pressing “erase/clear” and waiting until you see a “no codes” message, you can turn off your vehicle and disconnect the scanner.
Why is my Prius not turning on?
The most common causes that hinders normal starting operation of your Prius are dead key fob battery, dead high voltage battery, dead 12v battery, clogged fuel filter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.