1. There is a yellow plug under the dash plugged into the fuse panel.
2. Turn the ignition key to the “ON” (II) position.
3. When the SRS light comes back on plug the jumper wire back in within 4 seconds the light will blink twice and go out.
4. Unplug the jumper and turn the ignition key off.
Contents
What would cause the SRS light to come on?
If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
How do I turn off the SRS light on my Honda?
With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again.
How do I fix my SRS light?
1. Put the key into the ignition and turn the switch to the “on” position.
2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
3. Repeat Steps 1 and 2 two more times.
How much does it cost to fix SRS light?
What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic. In this instance, look for reputation versus cost, so do not shop just on price.
Can you drive with the SRS light on?
While you can certainly drive while your SRS light is on, it isn’t safe. You should get your vehicle to a service center as soon as possible so that a technician can inspect your SRS computer.13 avr. 2020
Will disconnecting the battery reset the airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. … Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.10 avr. 2020
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. … When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.27 jui. 2020
What does the red airbag light mean?
When this light is on, that means your airbags are deactivated. It means they will not deploy properly if you get into an accident. Needless to say, this is a serious issue that you will want to get rectified quickly for your safety and the safety of your passengers.3 avr. 2018
How do you turn the SRS light off?
How does Honda diagnose SRS light?
If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.31 déc. 2020
Where is the fuse for SRS light?
The fuse block is on the driver’s side of the engine compartment. Pull out the SRS fuse. In most models, this is fuse #40, located in the lower right corner of the fuse block. Turn the ignition switch to “ON” without starting the engine.12 jui. 2017
Should the SRS light be on?
When this light comes on, it indicates that a problem has been detected in the system, and one or more airbags may not inflate in the event of a collision. While it’s possible that all the airbags could work as intended even with an SRS warning light, a failure in the airbags is a significant safety concern.3 déc. 2019
What does SRS warning light mean?
Supplemental Restraint System
How do I get the SRS light off Mercedes?
Unfortunately, the SRS Airbag light doesn’t reset on its own. Even if the problem has been addressed, you will need an Airbag scanner to reset the light. Very often the light goes on because of a dying battery. But once the light is on, it will stay on even when you install a new battery, until you manually reset it.