1. Turn the ignition switch OFF, and wait for ten seconds.
2. Connect the SCS service connector to the MES connector.
3. Turn the ignition switch ON (II).
4. The SRS indicator light comes on for about six seconds.
5. The SRS indicator light comes on again.
6. The SRS indicator light goes off.
Contents
Can you drive with the SRS light on?
While you can certainly drive while your SRS light is on, it isn’t safe. You should get your vehicle to a service center as soon as possible so that a technician can inspect your SRS computer.13 avr. 2020
What does the SRS light mean on a Honda Accord?
The SRS, or supplemental restraint system, on your Honda Accord is responsible for deploying the airbag in the event of an accident. If this system is malfunctioning, the airbag may not deploy properly during an accident. … The yellow “SRS” light on the dash will light up, indicating a problem with the system.
How do you reset the SRS light on a 2000 Honda Accord?
1. Verify and make sure the ignition is switched OFF.
2. Connect the 2 pins in the MES with a paper clip or metal object.
3. Turn the ignition switch ON.
4. The SRS Indicator Light should come on for 6 seconds and then go off.
5. The SRS Indicator Light should come back on agian.
What would cause the SRS light to come on?
If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
How do you reset the SRS light on a Honda?
Step 2 – Reset the SRS light Turn the ignition off and connect each end of the paperclip to the pins on the MES connector. Turn the ignition on, and the SRS light will come on for six seconds before turning off. Disconnect the paper clip as soon as the light goes off. When light comes back on reconnect the paperclip.
How much does it cost to fix SRS light?
What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic. In this instance, look for reputation versus cost, so do not shop just on price.
What do you do when your SRS light comes on?
When you turn the ignition key to the “ON” position, the SRS light should come on momentarily, then extinguish. If the SRS light stays on, there’s a problem with the system and the air bags may not deploy in the event of a crash. You’ll want to seek professional diagnosis and repair as soon as possible.7 nov. 2019
How do I fix my SRS light?
1. Put the key into the ignition and turn the switch to the “on” position.
2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
3. Repeat Steps 1 and 2 two more times.
What SRS means?
Supplemental Restraint System
What does SRS mean on a 02 Honda Accord?
supplemental restraint system
Where is the fuse for SRS light?
The fuse block is on the driver’s side of the engine compartment. Pull out the SRS fuse. In most models, this is fuse #40, located in the lower right corner of the fuse block. Turn the ignition switch to “ON” without starting the engine.12 jui. 2017
Why is my SRS light on in my Honda Civic?
This light indicates that a fault has been detected and the airbags may not deploy or deploy properly in an accident. The SRS warning stands for Supplemental Restraint System. It supplements the primary restraint system, the seatbelts.
What is the meaning of SRS in Honda cars?
supplemental restraint system
How do I fix my SRS light on my Mitsubishi?
1. Plug the Mitsubishi airbag scanner into the OBD2 port under the dashboard, driver’s side.
2. Turn on the ignition and allow the scanner to power on.
3. Select your Mitsubishi model and year.
4. Select SRS / Airbag Control unit from the main menu.
5. Select Read Fault Codes.